3. Click Edit icon to edit the receiver parameters.
4. In the Status field, select either Enabled or Disabled option to change the
Deleting receivers
About this task
You can delete receivers that you are not going to use. Note that the deletion
occurs immediately. There is no warning message asking you to confirm this step.
1. Click Hub Admin > Hub Configuration > Receivers.
2. On the Receiver List window, click the Delete icon next to the receiver you
Localizing HTTP synchronous target time out
About this task
WebSphere Partner Gateway allows you to have a localized synchronous time out
and synchronous connection values for every HTTP Receiver. The synchronous
connection value cannot exceed the container allowed TCP connection limit. The
maximum synchronous connection per receiver alone is controlled in the super set
of container limit. Web container (WebSphere Application Server) is configured
separately through managed application to allow or limit the number of HTTP
connections. To modify the values of Max sync time out and Max sync
connection:
1. Navigate to Receiver creation page > Hubadmin > Receivers.
2. Click Edit icon corresponding to the HTTP receiver.
3. Modify the values of Max sync time out and Max sync connection.
Note: Max sync time out does not accept negative values. Entering the value zero
for Max synchronous connection removes the restriction of Max sync connection
over any receiver.
Managing interactions and document definitions
About this task
To enable, disable, or edit interactions between two document definitions, follow
these steps:
1. Click Hub Admin > Hub Configuration > Document Definition.
2. Click Manage Interactions.
3. Enter the search criteria that WebSphere Partner Gateway will use to find the
4. Click Search. The system finds all interactions that meet your search criteria.
5. To enable an interaction, click the Activate icon next to the interaction you
receiver status.
Note: The receiver in the following step is immediately deleted without a
warning message. Be sure that you want to delete the receiver.
want to delete.
interaction you want to enable, disable, or edit.
want to enable. Click OK to confirm. WebSphere Partner Gateway replaces the
Activate icon with the Deactivate icon. This indicates that the interaction is
enabled.
Chapter 4. Hub administration tasks
23