Table of Contents
Advertisement
Configuring tracing in a simple mode system
About this task
Setting up trace for a simple mode system is slightly different than for a
distributed mode system. To configure tracing for a simple mode system, use the
WebSphere Application Server admin console by browsing to http://<server-
address>:58090/admin.
The port 58090 is the default used by the installer, however this might be different
if the default port was not used during installation.
1. Locate the simple mode server named server1 in the console by clicking on
2. View the details of server1 by clicking its name in the list.
3. Scroll down until you see the Troubleshooting heading near the bottom of the
4. Click Diagnostic trace to see the details of the tracing configuration.
By default, the trace file for the simple mode WebSphere Partner Gateway
applications is configured as shown in Table 39. Because all of the WebSphere
Partner Gateway applications are deployed to server1, all the trace messages are
written to the same trace file. The trace file is written to the default directory of
<WebSphere Partner Gateway install dir>/wasND/profiles/<profile-name>/logs/
<server-name>. This is the same default directory where the log files are written.
By default, the simple mode installer does not set the logging level. The logging
level controls the amount of tracing information that is provided by components. If
you want any tracing for the WebSphere Partner Gateway applications, you must
specify logging levels. To change the logging levels, see "Setting log detail levels"
on page 144.
Setting tracing in a distributed mode system
About this task
To manage the trace files on a distributed mode installation, use the WebSphere
Application Server admin console for the deployment manager. Find this by
browsing to http://<server-address>/55090/admin.
The port 55090 is the default used by the installer, however the port can be
different if the default port was not used during installation.
1. Locate the server that you want to trace by clicking on Servers/Application
2. To view the details of the server you want to configure, select the server name
142
IBM WebSphere Partner Gateway Enterprise and Advanced Editions: Administration Guide
Servers/Application servers in the left pane to view the list of server names in
the right pane.
page. Clock Logging and Tracing under Troubleshooting
Table 39. Simple mode trace configuration
Application
Trace file name
All applications
trace.log
(Console,
Receiver, and
Document
Manager)
servers in the left pane to view the list of server names in the right pane.
in the list.
Format
Number of files
Basic
1
Maximum file
size
20 Mb
Advertisement
Table of Contents
