Installing/Removing Front Riggings; Installing; Removing - Invacare Van Seat User Manual

5 USAGE
5.4

Installing/Removing Front Riggings

CAUTION
If front riggings are used, then the seat MUST be adjusted to the highest mounting position - otherwise damage may occur.

Installing

1. If necessary, remove the footboard. Refer to owner's manual shipped with the wheelchair.
2. Turn front rigging to the side (open footplate is perpendicular to wheelchair) and position mounting holes in the front rigging hinge plates with
hinge pins on the wheelchair frame.
3. Install the front rigging hinge plates onto the hinge pins on the wheelchair frame.
4. Push the front rigging towards the inside of the wheelchair until it
locks into place.
The footplate will be on the inside of the

wheelchair when locked in place.
5. Repeat STEPS 1-4 for opposite side of wheelchair.

Removing

1. Push the front rigging release lever inward and rotate the footrest
out.
2. Lift up on front rigging and remove from the wheelchair.
3. Repeat STEPS 1-2 for opposite side of wheelchair.
Invacare® Van Seat
Hinge Pins
Front Rigging
Release Lever
FIGURE 3
28
Telescoping Front
Rigging Support
Front Rigging Hinge
Plate
Installing/Removing Front Riggings
Part No 1143195