Section 5-Front Riggings; Installing/Removing Front Riggings - Invacare Orbit Owner's Operator And Maintenance Manual

SECTION 5—FRONT RIGGINGS
SECTION 5—FRONT RIGGINGS
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely. Otherwise injury or damage may occur.

Installing/Removing Front Riggings

NOTE: For this procedure, refer to FIGURE 5.1.
Installing Front Riggings
1. Turn the front rigging assembly to the
side (open front rigging is
perpendicular to wheelchair).
2. Install the hinge plates on the front
rigging assembly onto the hinge pins
on the wheelchair frame.
3. Push the front rigging assembly
towards the inside of the wheelchair
until it locks into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat this procedure for the other
front rigging assembly.
5. To release the front rigging, push the
front rigging release lever inward,
rotate front rigging outward.
Removing Front Riggings
1. Push the front rigging release lever inward
2. Rotate swingaway front rigging assembly outward.
3. Lift the swingaway front rigging assembly off the hinge pins.
™
Orbit
WARNING
Footrest
Mounting
Pin
Mounting
Tube
NOTE: All swingaway style footrests are
installed the same way. Only one style of
footrest is shown for clarity
FIGURE 5.1 Installing/Removing Front
30
Footrest
Riggings
Part No. 1073955