Phwh93; Ph904A And Phal4A - Invacare Van Seat User Manual

PHWH93

1. Remove any accessory from the footrest(s).
Lay the footrest on a flat surface to simplify this

procedure.
2. Remove the footrest from the wheelchair. Refer to Installing/
Removing Front Riggings on page 28.
3. Remove the hex bolt, washers and locknut that secure the lower
footrest assembly to the upper footrest support (FIGURE 1).
4. Reposition the lower footrest to the desired height.
5. Reinstall the hex bolt, washers and locknut that secure the lower
footrest to the footrest support and tighten securely.
6. Repeat STEPS 1-5 for the opposite wheelchair footrest, if
necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/
Removing Front Riggings on page 28.
8. Reinstall any accessory onto the footrest(s).

PH904A and PHAL4A

1. Loosen, but DO NOT remove, the lug bolt and locknut that secure
the lower footrest to the footrest support.
2. Reposition the lower footrest to the desired height.
3. Securely tighten the lug bolt and locknut that secure the lower
footrest to the footrest support.
4. Repeat STEPS 1-3 for the opposite side of the wheelchair footrest,
if necessary.
PH904A style front rigging shown. PHAL4A front

rigging adjusts the same way.
Part No 1143195
Locknut
Coved
Washer
FIGURE 1 Footrest Height Adjustment - PHWH93
Footrest
Support
Lug Bolt
FIGURE 2
31
6 ADJUSTMENT
Footrest Support
Coved
Washer
Hex Bolt
Lower
Footrest
Locknut
Lower Footrest
Footrest Height Adjustment
Invacare® Van Seat