Replacing Heel Loops - Invacare Van Seat User Manual

7.5

Replacing Heel Loops

1. Note the position of hex bolt, coved washers and locknut for
reinstallation.
2. Remove the hex bolt, coved washers and locknut that secure the
lower footrest to the footrest support.
3. Remove the lower footrest.
4. Remove the phillips bolt, spacer and locknut that secure the existing
heel loop to the lower footrest.
5. Slide the existing heel loop off the lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
 When securing heel loop to lower footrest,
tighten the phillips screw and locknut until the
spacer is secure.
Part No 1143195
Locknut
Coved
Washer
Lower
Footrest
FIGURE 1
41
7 SETUP/MAINTENANCE
Footrest Support
Hex Bolt
Phillips Bolt
Spacer
Heel Loop
Locknut
Replacing Heel Loops
Invacare® Van Seat