Table of Contents
Advertisement
SECTION 7—BACK
Replacing the Locking Mechanism in the Back Cane
CAUTION
The locking mechanism in the back canes is spring loaded. Slowly remove the back
canes from the wheelchair to prevent the springs from being lost.
NOTE: For this procedure, refer to FIGURE 7.8.
NOTE: The following procedure is for non‐recliner wheelchairs only.
1. Move the back cane down and out of the way.
2. Unthread the actuator from the locking mechanism.
3. Slowly let the locking mechanism and spring slide out of the back cane.
NOTE: Inspect the spring and clean or replace if necessary.
4. Slide the new locking mechanism and spring into the back cane.
5. Make sure the angled end of the locking mechanism is pointing up towards the
locking pin on the adjustment plate.
6. Use Loctite 242 and securely tighten the actuator into the locking mechanism.
7. To lock the back canes, pull up on the back canes until there is an audible "click".
8. Push back and forth on the back canes to make sure they are locked in place.
Back Cane
Angled Portion of
Actuator
Locking Mechanism
Spring
Locking Mechanism
FIGURE 7.8 Replacing the Locking Mechanism in the Back Cane
71
Part No 1127114
Compass™XE and Allegro®
Advertisement
Table of Contents
Troubleshooting
