Installing/Removing T-Arms; Installing T-Arms; Removing T-Arms - Invacare Compass XE Owner's Operator And Maintenance Manual

Installing/Removing T-Arms

NOTE: For this procedure, refer to FIGURE 6.13.

Installing T-Arms

NOTE: If necessary, install the T‐Arm sockets.Refer to Installing the T‐Arm Sockets on page 57.
1. Position the T‐Arm over the T‐Arm
socket on the wheelchair frame.
NOTE: Make sure the locking lever is towards
the front of the wheelchair.
2. Slide T‐Arm into T‐Arm socket until the
locking lever is in the slot in the T‐Arm
socket and an audible ʺclickʺ is heard.
3. Pull UP on T‐Arm to make sure T‐Arm
is locked in place.
NOTE: If the T‐Arm does not slide in the T‐
Arm socket as desired, adjust the T‐Arm socket.
Refer to Adjusting T‐Arm Sockets on page 58.
4. Adjust the T‐Arm for desired height,
width and depth, if necessary. Refer to
Adjusting the T‐Arms on page 56.
5. Repeat STEPS 1‐4 for opposite side of
wheelchair.

Removing T-Arms

1. Press the locking lever in and lift the T‐Arm straight up and out of the T‐Arm socket.
NOTE: If the T‐Arm does not slide up and down in the T‐Arm socket as desired, adjust
the T‐Arm socket. Refer to Adjusting T‐Arm Sockets on page 58.
2. Repeat STEP 1 for opposite side of the wheelchair.
Part No 1127114
Wheelchair
Frame
T-Arm
Socket
FIGURE 6.13 Installing/Removing T-Arms
55
SECTION 6—ARMS
T-Arm
Locking Lever
(towards the front
of the wheelchair)
Slot
Compass™XE and Allegro®