Installing/Adjusting The Anti-Tippers; Installing The Anti-Tippers; Adjusting The Anti-Tippers - Invacare Compass XE Owner's Operator And Maintenance Manual

6. Push the opposite end of the elastic cord up and through the slotted hole in the wheel
lock extension handle.
7. Run the elastic cord through the washer and tie a knot in the elastic cord above the
washer.
8. Pull the elastic cord back down into the wheel lock extension handle.
9. Reinstall the black rubber tip onto the wheel lock extension handle.
10. Slide the wheel lock extension handle over the existing wheel lock handle.

Installing/Adjusting the Anti-Tippers

Anti-tippers MUST be fully engaged and spring buttons fully protruding out of
adjustment holes before using the wheelchair.
Make sure the anti-tipper wheels are pointing towards the ground/floor before using
the wheelchair.

Installing the Anti-Tippers

NOTE: For this procedure, refer to FIGURE 12.3.
1. Press the release buttons in and insert
the anti‐tippers with the anti‐tipper
wheels pointing toward the ground/
floor into the wheelchair frame until
the two locking pins are secured in
place.
NOTE: A 1½ to 2 inch clearance between the
bottom of the anti‐tipper wheels and the
ground/floor must be maintained at all times.
2. Adjust the anti‐tippers. Refer to Adjusting the Anti‐Tippers on page 123.

Adjusting the Anti-Tippers

NOTE: For this procedure, refer to FIGURE 12.4.
1. Press the spring button on the wheeled
portion of the anti‐tipper and slide it up
or down to achieve a 1½ to 2‐inch
clearance.
2. Check to make sure that the spring
buttons are fully engaged in
adjustment holes.
Part No 1127114
SECTION 12—WHEELOCKS AND ANTI-TIPPERS
WARNING
Wheelchair
Frame
Locking Pins
FIGURE 12.3 Installing the Anti-Tippers
FIGURE 12.4 Adjusting the Anti-Tippers
123
Anti-Tipper
Release Buttons
Spring Button
1½ to 2-inch Clearance
Compass™XE and Allegro®