Installing Rigid Side Guards - Invacare Compass XE Owner's Operator And Maintenance Manual

SECTION 6—ARMS

Installing Rigid Side Guards

NOTE: For this procedure, refer to FIGURE 6.22.
1. Position the unthreaded half clamp on the inside of the wheelchair frame.
2. Position the threaded half clamp on the outside of the wheelchair frame.
3. Install the washer and socket screw through the two half clamps and loosely tighten.
4. Slide the rigid side guard into the slot on the threaded half clamp.
5. Determine the necessary position for the rigid side guard.
6. Securely tighten the two half clamps together with the socket screw.
Washer
Socket Screw
Unthreaded Half Clamp
Rigid Side Guard
Threaded Half Clamp
Wheelchair Frame
FIGURE 6.22 Installing Rigid Side Guards
62
Compass™XE and Allegro® Part No 1127114