Invacare Compass XE Owner's Operator And Maintenance Manual page 106

SECTION 10—WHEELS
DO NOT inflate tire until it is completely assembled.
6. Inflate the tire to the correct p.s.i. rating on the sidewall of the tire.
Make sure detent pin and locking pins of the quick/quad-release axles are fully
released BEFORE operating the wheelchair.
7. Reinstall rear wheel to the wheelchair. Refer to Removing/Installing Rear Wheels on
page 101.
8. If the locking pins of the quick/quad‐release axles are not protruding past the inside
of the axle bushing or there is too much movement of the rear wheel assembly in a
back and forth position, refer to Adjusting the Quick‐Release Axle on page 103 or
Adjusting the Quad‐Release Axle on page 104.
9. Repeat the procedure for the opposite rear wheel if necessary
10. Remove the rear wheel from the wheelchair. Refer to Removing/Installing Rear
Wheels on page 101.
11. Remove the button screws and washers that secure the handrim to the rear wheel.
12. Remove the existing handrim.
13. Install the new handrim by reversing
the above procedures.
WARNING
Make sure detent pin and locking pins of
the quick/quad-release axles are fully
released BEFORE operating the
wheelchair.
14. Reinstall rear wheel to the wheelchair.
Refer to Removing/Installing Rear
Wheels on page 101.
15. If the locking pins are not protruding
past the inside of the axle bushing or
there is too much movement of the rear
wheel assembly in a back and forth
position, refer to Adjusting the Quick‐
Release Axle on page 103 or Adjusting
the Quad‐Release Axle on page 104.
16. Repeat the procedure for the opposite
rear wheel if necessary.
Compass™XE and Allegro®
WARNING
WARNING
DETAIL "A" - SPOKE REAR WHEELS
Handrim
Locknut
DETAIL "B" - COMPOSITE REAR WHEELS
Handrim
FIGURE 10.5 Composite Rear Wheels
106
Mounting
Screw
Button Screw
Part No 1127114