Spoke Rear Wheels - Invacare Compass XE Owner's Operator And Maintenance Manual

SECTION 10—WHEELS
FIGURE 10.6 Installing Projection Handrims Composite Rear Wheels

Spoke Rear Wheels

NOTE: For this procedure, refer to FIGURE 10.7 on page 109.
1. Remove the rear wheel from the wheelchair. Refer to Removing/Installing Rear
Wheels on page 101.
Tire MUST be deflated before any disassembly procedures are performed.
2. Remove all air from the bar by pressing down on the pin in the center of the valve
stem.
3. While carefully holding the tire, bar and rim strip to one side, hold the mounting
screws and remove the locknuts that secure the handrim to the rear wheel.
4. Remove the existing handrim from the rear wheel.
5. Position the projection handrim mounting holes with the mounting holes in the rear
wheel.
6. While carefully holding the tire, bar and rim strip to one side, hold the mounting
screw and securely tighten the locknuts that secure the handrim to the rear wheel.
Compass™XE and Allegro®
Links at an approximate 45°
angle in the same direction
Long
Screw
Link
Short Screw
WARNING
108
Locknut
Washer
Part No 1127114