Installing New Recliner Cables - Invacare Compass XE Owner's Operator And Maintenance Manual

7. Unscrew the fitting end of the existing recliner cable from the trigger release lever.
8. Unscrew the cable locking nut that secures the existing recliner cable to the actuator
housing.
9. Remove the end of the existing recliner cable from the actuator.
10. Remove the existing recliner cable from the wheelchair.
See Detail "A"
Actuator
Locknut
Housing
Cable
Locking
Nut

Installing New Recliner Cables

1. Screw the new recliner cable into the trigger release lever until the fitting end of the
cable is flush with the inside of the handle. Refer to Detail ʺAʺ of FIGURE 11.2.
2. Reinstall the locknut into the trigger release lever, if necessary.
NOTE: Refer to Detail ʺAʺof FIGURE 11.2 for STEPS 3‐6.
3. Install the end of the new recliner cable into the slot in the trigger release lever.
4. Screw the cable locking collar onto the trigger release lever until the collar bottoms out
on the trigger release lever.While holding the cable locking collar and locking nut,
tighten the cable locking nut against the cable locking collar.
5. Reposition the trigger release lever on the back cane.
6. Secure the trigger release lever to the back cane with the mounting bolt and locknut.
DO NOT over tighten the new cable into the actuator housing. Damage to the
actuator housing can occur.
7. Screw the end of the new recliner cable into the actuator housing until new cable is
tightened securely.
8. Install the end of the new recliner cable onto the actuator.
NOTE: Make sure the new recliner cable is positioned in the slot in the actuator.
Part No 1127114
Mounting
Bolt
Back
Cane
Tie
Wraps
FIGURE 11.2 Replacing the Recliner Cables
CAUTION
117
SECTION 11—RECLINER
DETAIL "A"
Trigger
Release
Lever
Cable Locking
Cable Locking
Nut
Compass™XE and Allegro®
Recliner
Cable
Fitting End
Collar