Table of Contents
Advertisement
4.8 Adjusting Quad-Release Handles
Remove rear wheel and the quad-release axle A from the
1.
wheelchair. Refer to .
Loosen the locking screw B.
2.
3.
Make one or both of the following adjustments:
•
If the quad release handle A is not releasing the locking pins
completely, rotate the quad-release handle A approximately
one-quarter turn clockwise.
•
If the quad-release handle A hits the spokes of the rear
wheel when assembled, rotate the quad-release handle A
approximately one-quarter turn counterclockwise.
Tighten the locking screw B.
4.
Install the rear wheel and quad-release axle A onto the
5.
wheelchair. Refer to .
Flip the handle of the quad-release axle A down to release the
6.
detent pin ensuring that the locking pins are fully released.
7.
Repeat this procedure until the quad-release axle locks correctly.
1171801-A
4.9 Removing Play from Rear Wheels
With the rear wheel and quad-release axle A still mounted on the
wheelchair, tighten the length adjusting screw C until there is no in
and out movement of the quad-release axle A and rear wheel.
Refer to diagram in 4.8 Adjusting Quad-Release Handles,
page 35
4.10 Opening/Closing Camber Clamps
WARNING!
STANDARD AND SUSPENSION CAMBER
CLAMPS
– Make sure the hex screws are securely tightened
before using wheelchair, otherwise personal injury or
damage to the wheelchair may occur.
QUICK RELEASE LEVERS
– Make sure the quick release levers are in the closed
position before using the wheelchair, otherwise
personal injury or damage to the wheelchair may
occur.
CAUTION!
ADJUSTABLE CAMBER SYSTEM ONLY
– DO NOT close the quick-release levers or tighten the
socket screws or hex screws without camber inserts
in the axle tube. Damage to the axle tube will occur.
1.
Perform one of the following to open a camber clamp:
•
Quick-Release Levers - Pull the quick release lever A to
the open position D.
•
Standard Camber Clamps - Loosen, but do not remove the
socket screw B on the camber clamp A.
Operation
35
Advertisement
Table of Contents
