Brocade Communications Systems Brocade 8/12c Administrator's Manual page 170

3
CryptoTarget container configuration
3. Add an initiator to the CryptoTarget container. Enter the cryptocfg
4. Commit the transaction. The commit operation creates the virtual devices and the redirection
CAUTION
When configuring a multi-path LUN, you must complete the CryptoTarget container configuration
for ALL target ports in sequence and add the hosts that should gain access to these ports before
committing the container configuration. Failure to do so results in data corruption. Refer to the
section
5. Display the CryptoTarget container configuration. The virtual initiator and virtual target have
6. Display the redirection zone. It includes the host, the target, the virtual initiator, and the virtual
150
•
The CryptoTarget container name can be up to 31 characters in length and may include
any alphanumeric characters, hyphens, and underscore characters.
•
You may add initiators at this point or after you create the container.
The following example creates a disk container named my_disk_tgt1. The initiator is added in
step 3.
FabricAdmin:switch>cryptocfg --create -container disk my_disk_tgt \
10:00:00:00:05:1e:41:9a:7e 20:0c:00:06:2b:0f:72:6d 20:00:00:06:2b:0f:72:6d
Operation Succeeded
followed by the initiator port WWN and the node WWN.
Note that the initiator port WWN must also be added to the LUN when the LUN is added to the
CryptoTarget container.
FabricAdmin:switch>cryptocfg --add -initiator my_disk_tgt \
10:00:00:00:c9:2b:c9:3a 20:00:00:00:c9:2b:c9:3a
Operation Succeeded
zone that routes traffic through these devices.
FabricAdmin:switch>cryptocfg --commit
Operation Succeeded
"Configuring a multi-path Crypto LUN"
been created automatically upon commit, and there are no LUNs configured yet.
FabricAdmin:switch>cryptocfg --show -container my_disk_tgt -cfg
Container name:
Type:
EE node:
EE slot:
Target:
VT:
Number of host(s):
Configuration status: committed
Host:
VI:
Number of LUN(s):
Operation Succeeded
target.
FabricAdmin:switch>cfgshow
Defined configuration:
on page 166 for specific instructions.
my_disk_tgt
disk
10:00:00:05:1e:41:9a:7e
0
20:0c:00:06:2b:0f:72:6d 20:00:00:06:2b:0f:72:6d
20:00:00:05:1e:41:4e:1d 20:01:00:05:1e:41:4e:1d
1
10:00:00:00:c9:2b:c9:3a 20:00:00:00:c9:2b:c9:3a
20:02:00:05:1e:41:4e:1d 20:03:00:05:1e:41:4e:1d
0
add -initiator command
--
Fabric OS Encryption Administrator's Guide
53-1002159-03