Brocade Communications Systems Brocade 8/12c Administrator's Manual page 138

3
Configuring cluster links
Node is a group leader node
1. Log in to the group leader as Admin or SecurityAdmin.
2. Reboot the encryption switch/DCX (both active and standby central processors) so the existing
3. After the encryption group is converged, complete the steps noted in
Node is a member node
1. Log in to the Group Leader as Admin or SecurityAdmin.
2. Eject and deregister the node from the encryption group.
3. Change the IP address of the member node using the new IP address.
4. Reboot the member node (the node on which the IP address has been modified).
5. Re-register the node with the Group Leader using new IP address.
NOTE
A reboot is not needed beginning with Fabric OS v6.4.0.
118
Group Leader fails over and one of the member nodes assumes the role of Group Leader.
a. If the EG is not a single node EG, reboot the encryption switch/DCX (both active and
standby central processors) so the existing Group Leader fails over and one of the member
nodes assumes the role of Group Leader.
b. If the node is a single node EG, complete the following steps:
1. Delete the encryption group.
2. Change the IP of the switch.
3. Create the encryption group.
node".
"Node is a member
Fabric OS Encryption Administrator's Guide
53-1002159-03