HP 6125G Configuration Manual page 56

Step
7. Apply an AAA
authentication scheme
to the intended
domain.
8. Create a local user
and enter local user
view.
9. Set a password for the
local user.
10. Specify the command
level of the local user.
11. Specify terminal
service for the local
user.
12. Configure common
settings for the AUX
user interfaces.
The next time you attempt to dial in to the device, you must provide the configured username and
password, as shown in
Command
a. Enter the ISP domain view:
domain domain-name
b. Apply the specified AAA
scheme to the domain:
authentication default
{ hwtacacs-scheme
hwtacacs-scheme-name
[ local ] | local | none |
radius-scheme
radius-scheme-name
[ local ] }
c. Exit to system view:
quit
local-user user-name
password { cipher | simple }
password
authorization-attribute level level
service-type terminal
See "Configuring common settings
for modem dial-in (optional)."
Figure 26.
50
Remarks
Optional.
By default, local authentication is used.
For local authentication, configure local
user accounts.
For RADIUS or HWTACACS
authentication, configure the RADIUS or
HWTACACS scheme on the device and
configure authentication settings
(including the username and password)
on the server.
For more information about AAA
configuration, see Security Configuration
Guide.
By default, no local user exists.
By default, no password is set.
Optional.
By default, the command level is 0.
By default, no service type is specified.
Optional.