Snmp Login Control Configuration Example - HP 6125G Configuration Manual

Step
5. Apply the ACL to an
SNMP community, group
or user.

SNMP login control configuration example

Network requirements
As shown in
Figure 33 Network diagram
Command
•
•
•
•
•
Figure 33, configure the device to allow only NMS users from Host A and Host B to access.
SNMPv1/v2c community:
snmp-agent community { read | write }
community-name [ mib-view view-name ]
[ acl acl-number | acl ipv6
ipv6-acl-number ] *
SNMPv1/v2c group:
snmp-agent group { v1 | v2c }
group-name [ read-view read-view ]
[ write-view write-view ] [ notify-view
notify-view ] [ acl acl-number | acl ipv6
ipv6-acl-number ] *
SNMPv3 group:
snmp-agent group v3 group-name
[ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ]
[ notify-view notify-view ] [ acl acl-number
| acl ipv6 ipv6-acl-number ] *
SNMPv1/v2c user:
snmp-agent usm-user { v1 | v2c }
user-name group-name [ acl acl-number |
acl ipv6 ipv6-acl-number ] *
SNMPv3 user:
snmp-agent usm-user v3 user-name
group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password [ privacy-mode { 3des |
aes128 | des56 } priv-password ] ] [ acl
acl-number | acl ipv6 ipv6-acl-number ] *
68
Remarks
For more information about
SNMP, see Network
Management and
Monitoring Configuration
Guide.