HP 6125G Configuration Manual page 58

Step
6. Configure the number of stop
bits.
7. Configure the number of data
bits in each character.
8. Define a shortcut key for
starting a session.
9. Define a shortcut key for
terminating tasks.
10. Configure the flow control
mode.
11. Specify the terminal display
type.
12. Configure the user privilege
level for login users.
13. Set the maximum number of
lines to be displayed on a
screen.
14. Set the size of the command
history buffer.
Command
stopbits { 1 | 1.5 | 2 }
databits { 7 | 8 }
activation-key character
escape-key { default | character }
flow-control { hardware | none |
software }
terminal type { ansi | vt100 }
user privilege level level
screen-length screen-length
history-command max-size value
52
Remarks
The default is 1.
Stop bits indicate the end of a
character. The more the bits, the
slower the transmission.
By default, the number of data bits in
each character is 8.
The setting depends on the
character coding type. For example,
you can set it to 7 if standard ASCII
characters are to be sent, and set it
to 8 if extended ASCII characters
are to be sent.
By default, press Enter to start a
session.
By default, press Ctrl+C to terminate
a task.
By default , the flow control mode is
none.
The device supports only the none
mode.
By default, the terminal display type
is ANSI.
The device supports two terminal
display types: ANSI and VT100. HP
recommends setting the display type
to VT100 for both the device and the
client. If the device and the client use
different display types or both use
the ANSI display type, when the
total number of characters of a
command line exceeds 80, the
screen display on the terminal might
be abnormal. For example, the
cursor might be displayed at a
wrong place.
3 by default.
By default, a screen displays 24
lines at most.
A value of 0 disables the function.
By default, the buffer saves 10
history commands at most.