Enabling Mld; Configuring The Mld Version; Configuring Static Joining - HP 6125G Configuration Manual

Determine the maximum number of IPv6 multicast groups that an interface can join.
•

Enabling MLD

Enable MLD on the interface on which IPv6 multicast group memberships will be created and
maintained.
To enable MLD:
Step
1. Enter system view.
2. Enable IPv6 multicast routing.
3. Enter interface view.
4. Enable MLD.
For more information about the multicast ipv6 routing-enable command, see IP Multicast Command
Reference.

Configuring the MLD version

Because MLD message types and formats vary with MLD versions, the same MLD version should be
configured for all routers on the same subnet before MLD can work properly.
Configuring an MLD version globally
Step
1. Enter system view.
2. Enter MLD view.
3. Configure an MLD version
globally.
Configuring an MLD version on an interface
Step
1. Enter system view.
2. Enter interface view.
3. Configure an MLD version on
the interface.

Configuring static joining

After an interface is configured as a static member of an IPv6 multicast group or an IPv6 multicast source
and group, it will act as a virtual member of the IPv6 multicast group to receive IPv6 multicast data
addressed to that IPv6 multicast group for the purpose of testing IPv6 multicast data forwarding.
Command
system-view
multicast ipv6 routing-enable
interface interface-type
interface-number
mld enable
Command
system-view
mld
version version-number
Command
system-view
interface interface-type
interface-number
mld version version-number
267
Remarks
N/A
Disable by default
N/A
Disabled by default
Remarks
N/A
N/A
MLDv1 by default
Remarks
N/A
N/A
MLDv1 by default