Configuring Igmp Ssm Mapping; Enabling Ssm Mapping; Configuring Ssm Mappings; Configuring Igmp Proxying - HP 6125G Configuration Manual

Ip multicast configuration guide
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

Configuring IGMP SSM mapping

Because of some possible restrictions, some receiver hosts on an SSM network might run IGMPv1 or
IGMPv2. To provide SSM service support for these receiver hosts, configure the IGMP mapping feature
on the last-hop router.
Before you configure the IGMP SSM mapping feature, complete the following tasks:
Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
Configure basic IGMP functions.

Enabling SSM mapping

Step
1.
Enter system view.
2.
Enter interface view.
3.
Enable the IGMP SSM
mapping feature.
NOTE:
To ensure SSM service for all hosts on a subnet, regardless of the IGMP version running on the hosts,
enable IGMPv3 on the interface that forwards multicast traffic onto the subnet.

Configuring SSM mappings

By performing this configuration multiple times, you can map a multicast group to different multicast
sources.
If IGMPv3 is enabled on a VLAN interface of a switch, and if a port in that VLAN is configured as a
simulated host, the simulated host will send IGMPv3 reports even if you did not specify a multicast source
when you configure simulated joining with the igmp-snooping host-join command. In this case, the
corresponding multicast group will not be created based on the configured IGMP SSM mappings. For
more information about the igmp-snooping host-join command, see IP Multicast Command Reference.
To configure an IGMP SSM mapping:
Step
1.
Enter system view.
2.
Enter IGMP view.
3.
Configure an IGMP SSM
mapping.

Configuring IGMP proxying

Before you configure the IGMP proxying feature, complete the following tasks:
Command
system-view
interface interface-type
interface-number
igmp ssm-mapping enable
Command
system-view
igmp
ssm-mapping group-address { mask |
mask-length } source-address
90
Remarks
N/A
N/A
Disabled by default
Remarks
N/A
N/A
No IGMP mappings are
configured by default.

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents