Sa Message Filtering Configuration - HP 6125G Configuration Manual

No information is output on Switch B.
# Display PIM routing information on Switch D.
[SwitchD] display pim routing-table
Total 1 (*, G) entry; 1 (S, G) entry
(*, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: WC
UpTime: 00:12:07
Upstream interface: Register
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200
(10.110.6.100, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: SPT 2MSDP ACT
UpTime: 00:40:22
Upstream interface: Vlan-interface104
Upstream neighbor: 10.110.4.2
RPF prime neighbor: 10.110.4.2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200

SA message filtering configuration

Network requirements
As shown in
domains to provide unicast routing.
Loopback 0 is configured as a C-BSR and a C-RP in the related PIM-SM domains on Switch A, Switch C,
and Switch D, respectively.
An MSDP peering relationship is set up between Switch A and Switch C and between Switch C and
Switch D.
Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source 2 sends
multicast data to multicast group 227.1.1.0/30.
Configure SA message filtering rules so that receivers Host A and Host B can receive only the multicast
data addressed to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Host can receive only the
multicast data addressed to multicast groups 226.1.1.0/30 and 227.1.1.0/30.
Protocol: igmp, UpTime: 00:12:07, Expires: -
Protocol: pim-sm, UpTime:
Figure 57, three PIM-SM domains exist in the network, and OSPF runs within and among the
- , Expires: -
180