Configuring Default Route Redistribution Into Mbgp - HP 6125G Configuration Manual

Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv4 MBGP address
family view.
4. Configure MBGP route
redistribution.
NOTE:
The networks to be injected must exist in the local IP routing table, and using a routing policy makes route
control more flexible.

Configuring default route redistribution into MBGP

You cannot use the import-route command to redistribute any default route into the MBGP routing table.
This task allows you to redistribute default routes in another way.
To configure MBGP to redistribute a default route from another protocol:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter MBGP address family
view.
4. Enable route redistribution
from another routing protocol.
5. Enable default route
redistribution into the MBGP
routing table.
Command
system-view
bgp as-number
ipv4-family multicast
Enable route redistribution from
another routing protocol:
import-route protocol [ { process-id
| all-processes } [ allow-direct |
med med-value | route-policy
route-policy-name ] * ]
Inject a network into the MBGP
routing table:
network ip-address [ mask |
mask-length ] [ short-cut |
route-policy route-policy-name ]
Command
system-view
bgp as-number
ipv4-family multicast
import-route protocol [ { process-id
| all-processes } [ allow-direct |
med med-value | route-policy
route-policy-name ] * ]
default-route imported
188
Remarks
N/A
N/A
N/A
Use either command
No route redistribution is
configured by default.
The allow-direct keyword is
available only when the specified
routing protocol is OSPF.
The ORIGIN attribute of routes
redistributed into the MBGP routing
table with the import-route
command is Incomplete.
The ORIGIN attribute of routes
injected into the MBGP routing
table with the network command is
IGP.
Remarks
N/A
N/A
N/A
No route redistribution is
configured by default.
The allow-direct keyword is
available only when the specified
routing protocol is OSPF.
Not enabled by default.