HP 6125G Configuration Manual page 289

Figure 78 Network diagram
IPv6 PIM network
Vlan-int101
Vlan-int201
Vlan-int202
Configuration procedure
Enable IPv6 forwarding on each switch and configure an IP address and prefix length for each
1.
interface as shown in
Configure OSPFv3 on the switches on the IPv6 PIM network to make sure the switches are
2.
interoperable at the network layer and they can dynamically update their routing information.
(Details not shown.)
Enable the IPv6 multicast routing, MLD and IPv6 PIM-DM:
3.
# Enable IPv6 multicast routing on Switch A, enable MLD on VLAN-interface 100, and enable IPv6
PIM-DM on each interface.
<SwitchA> system-view
[SwitchA] multicast ipv6 routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] pim ipv6 dm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim ipv6 dm
[SwitchA-Vlan-interface101] quit
# Enable IPv6 multicast routing on Switch B, enable MLD on VLAN-interface 200, and enable IPv6
PIM-DM on each interface.
<SwitchB> system-view
[SwitchB] multicast ipv6 routing-enable
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] mld enable
[SwitchB-Vlan-interface200] pim ipv6 dm
[SwitchB-Vlan-interface200] quit
[SwitchB] interface vlan-interface 201
Vlan-int100
3000::12/64
Switch A
Querier
Vlan-int200
3001::10/64
Switch B
Vlan-int200
3001::12/64
Switch C
Figure 78. (Details not shown.)
Receiver
Host A
N1
Host B
Receiver
Host C
N2
Host D
278