Displaying And Maintaining Mld Snooping; Mld Snooping Configuration Examples; Ipv6 Group Policy And Simulated Joining Configuration Example - HP 6125G Configuration Manual

Ip multicast configuration guide
Hide thumbs Also See for 6125G:
Table of Contents

Advertisement

Step
3.
Set the DSCP value for MLD
messages.

Displaying and maintaining MLD snooping

Task
Display MLD snooping group
information.
Display information about the hosts
tracked by MLD snooping.
Display IPv6 static multicast
MAC address entries.
Display statistics for the MLD
messages learned through MLD
snooping.
Remove dynamic group entries of
a specified MLD snooping group
or all MLD snooping groups.
Clear statistics for the MLD
messages learned through MLD
snooping.

MLD snooping configuration examples

IPv6 group policy and simulated joining configuration example

Network requirements
As shown in
acts as the MLD querier on the subnet.
The receivers, Host A and Host B can receive IPv6 multicast traffic addressed to IPv6 multicast group
FF1E::101 only.
Figure
62, MLDv1 runs on Router A, MLDv1 snooping required on Switch A, and Router A
Command
dscp dscp-value
Command
display mld-snooping group [ vlan
vlan-id ] [ slot slot-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
display mld-snooping host vlan
vlan-id group ipv6-group-address
[ source ipv6-source-address ] [ slot
slot-number ] [ | { begin | exclude
| include } regular-expression ]
display mac-address
[ mac-address [ vlan vlan-id ] |
[ multicast ] [ vlan vlan-id ]
[ count ] ] [ | { begin | exclude
| include } regular-expression ]
display mld-snooping statistics [ |
{ begin | exclude | include }
regular-expression ]
reset mld-snooping group
{ ipv6-group-address | all } [ vlan
vlan-id ]
reset mld-snooping statistics
226
Remarks
By default, the DSCP value in MLD
messages is 48.
Remarks
Available in any view.
Available in any view.
Available in user view.
Available in any view.
Available in user view.
This command works only on an
MLD snooping–enabled VLAN, but
not in a VLAN with MLD enabled
on its VLAN interface.
This command cannot remove the
static group entries of MLD
snooping groups.
Available in user view.

Advertisement

Table of Contents
loading

This manual is also suitable for:

6125 blade switch series

Table of Contents