Step
3.
Enable IPv6 multicast forwarding
on a non-querier downstream
interface.
Displaying and maintaining MLD
CAUTION:
The reset mld group command might cause multicast data transmission failures.
To display and maintain MLD:
Task
Display MLD group information.
Display Layer 2 port information
about MLD groups.
Display information about the hosts
tracked by MLD on the Layer 2
ports.
Display MLD configuration and
running information on the
specified interface or all
MLD-enabled interfaces.
Display the information of the MLD
proxying groups.
Display the information of the MLD
routing table.
Display MLD SSM mappings.
Command
mld proxying forwarding
Command
display mld group
[ ipv6-group-address | interface
interface-type interface-number ]
[ static | verbose ] [ | { begin |
exclude | include }
regular-expression ]
display mld group port-info [ vlan
vlan-id ] [ slot slot-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
display mld host port-info vlan
vlan-id group ipv6-group-address
[ source ipv6-source-address ]
[ vlan vlan-id ] [ slot slot-number ]
[ | { begin | exclude | include }
regular-expression ]
display mld interface
[ interface-type interface-number ]
[ verbose ] [ | { begin | exclude |
include } regular-expression ]
display mld proxying group
[ group-address ] [ verbose ] [ |
{ begin | exclude | include }
regular-expression ]
display mld routing-table
[ ipv6-source-address
[ prefix-length ] |
ipv6-group-address [ prefix-length ]
| flags { act | suc } ] * [ | { begin |
exclude | include }
regular-expression ]
display mld ssm-mapping
ipv6-group-address [ | { begin |
exclude | include }
regular-expression ]
276
Remarks
Disabled by default
Remarks
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Available in any view.
Available in any view.