Configuring Join/Prune Message Sizes - HP 6125G Configuration Manual

NOTE:
If no special networking requirements are raised, use the default settings.
Configuring PIM common timers globally
Step
1. Enter system view.
2. Enter PIM view.
3. Configure the hello interval.
4. Configure the join/prune
interval.
5. Configure the join/prune
timeout time.
6. Configure assert timeout time.
7. Configure the multicast source
lifetime.
Configuring PIM common timers on an interface
Step
1. Enter system view.
2. Enter interface view.
3. Configure the hello interval.
Configure the maximum delay
4.
between hello messages.
5. Configure the join/prune
interval.
6. Configure the join/prune
timeout time.
7. Configure assert timeout time.

Configuring join/prune message sizes

A large size of a join/prune message might result in loss of a larger amount of information if a message
is lost. You can set a small value for the size of each join/prune message to reduce the impact in case of
the loss of a message.
Command
system-view
pim
timer hello interval
timer join-prune interval
holdtime join-prune interval
holdtime assert interval
source-lifetime interval
Command
system-view
interface interface-type
interface-number
pim timer hello interval
pim triggered-hello-delay interval
pim timer join-prune interval
pim holdtime join-prune interval
pim holdtime assert interval
133
Remarks
N/A
N/A
Optional.
30 seconds by default.
Optional.
60 seconds by default.
Optional.
210 seconds by default.
Optional.
180 seconds by default.
Optional.
210 seconds by default.
Remarks
N/A
N/A
Optional.
30 seconds by default.
Optional.
5 seconds by default.
Optional.
60 seconds by default.
Optional.
210 seconds by default.
Optional.
180 seconds by default.