Get Files Via Ftp - Oce TDS320 User Manual

Get files via FTP

Launch an FTP client.
1
Enter the 'ftp' command.
2
A DOS box now appears with the FTP prompt.
Enter the 'Open' command followed by either the registered name of the Océ
3
Power Logic® Controller or the IP address (for example: 194.2.66.146) to
connect to the Controller and press Enter: 'open 194.2.66.146'.
Instead of performing steps 2 and 3 you could also enter "ftp
Note:
host_name" in the FTP client.
The connection with the Controller is now established and a window appears
asking you for a user name.
Enter your user name 'anonymous', and enter as your password also
4
'anonymous'.
A connection is now set up for the default user 'anonymous'.
As there is no registered user, you can press Enter to initiate the
Note:
connection.
Set the transmission mode to binary by entering 'binary'.
5
Go to the 'tempstore' directory using the following command: 'cd tempstore\'.
6
Go to the 'scan' directory if you want to retrieve a file from a destination on
7
the local host,
or
go to the 'unsent' directory if you want to retrieve a file from 'unsent' folder
on the local host.
Get the data file (for example: bugatti.tif) via the 'get' command:
8
'get bugatti.tif'.
Quit FTP by entering the 'bye' command.
9
You can retrieve multiple files by the 'mget *' command or the 'mget .'
Note:
command. Which command you can use is release dependent.
78 Océ TDS320 User Manual