Lexmark Pro4000 Series User Manual page 11

About your printer
Use the
2 ADF input tray
3 PictBridge and USB port
4 Card reader light
5 Memory card slot
6 Ink cartridge access door Install, remove, or replace ink cartridges.
7 Paper tray (Tray 1)
8 Second paper tray (Tray 2)
Note: This option is
available only in select
printer models.
9 Exit bin
10 Bin extender
11 Printer control panel
Use the
12 Customer support
label
13 Scanner glass
14 Power supply with port Connect the printer to the power cord.
To
Load original documents into the ADF.
Notes:
•
Do not load postcards, photos, small items, or thin media (such as magazine
clippings) into the ADF. Place these items on the scanner glass.
• After scanning, copying, or faxing, you can lift the right end of the input tray to
retrieve the original documents easily.
Connect a PictBridge-enabled digital camera or a flash drive to the printer.
Check the card reader status. The light comes on when a memory card is inserted and
blinks when a memory card is being accessed.
Insert a memory card.
Load paper.
Load additional paper.
You can load the same type of paper as in Tray 1. You can also load a different type of
paper and change the default paper settings so the printer uses paper from Tray 2 for
certain types of print jobs.
Hold paper as it exits.
Note: For the printer to be ready for any print job, make sure to fully extend the exit
bin and to flip out the bin extender.
Catch the paper as it exits.
Note: For the printer to be ready for any print job, make sure to fully extend the exit
bin and to flip out the bin extender.
Operate the printer.
To
Identify the model number of the printer, the customer support hot line, and the ink
cartridge information.
Scan, copy, or fax photos and documents.
11