Resolved Caveats-Cisco Ios Xe Release 3.7(4)S - Cisco ASR 903 Release Notes

Hide thumbs Also See for ASR 903:
Table of Contents

Advertisement

Caveats in Cisco IOS XE 3.7S Releases
Resolved Caveats—Cisco IOS XE Release 3.7(4)S
This section documents the resolved caveats for the Cisco ASR 903 Router in Cisco IOS XE Release
3.7(4)S
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
8
Symptom: Few CFM primary sessions stays inactive.
Conditions: This issue occurs when CFM domain with SLA is configured.
Workaround: There is no workaround.
CSCui87257
Symptom: The interface clock is not detected after a switchover
Conditions: This issue occurs after a switvchover is performed from RSP0 to RSP1.
Workaround: There is no workaround.
CSCtz43467
Symptom: All commands listed under the REP configuration modes cannot be configured. This
was seen while configuring REP with BDI and configuring more than one source ports in a span
session.
Conditions: This issue occurs in normal working conditions.
Workaround: There is no workaround.
CSCua95675
Symptom: An Ethernet virtual circuit (EVC) interface stops forwarding traffic.
Conditions: This issue occurs when multiple EVCs are configured on a single interface. The EVCs
have the same outer tag VLAN.When one of the EVCs is removed from the configuration, the other
EVCs with the same outer tag VLAN stop passing traffic.
Workaround: Issue a shutdown command followed by a no shutdown command on the Ethernet
interface.
CSCuc60148
Symptom: System does not shut down when the temperature sensor reaches shutdown threshold
region.
Conditions: This issue occurs when the temperature sensors reaches the shutdown threshold
region.
Workaround: Configure the facility-alarm critical exceed-action shutdown command has to
enable this system shutdown behavior.
CSCud61551
Symptom: Serial Number of the RSP in slot 1 is not displayed some times in the show inventory
command output.
Conditions: This issue occurs under normal working conditions.
Workaround: Reload the router again.
CSCue24621
Symptom: When one EFP is shut, traffic get stops for other EVCs.
Conditions: This issue occurs where there are multiple qinq EFPs with same outer vlan tag on one
interface.
Chapter
OL-26630-08

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents