Cisco ASR 903 Release Notes page 272

Chapter
CSCug96958
•
Symptom: IMA interfaces stay up when controller is shutdown.
Conditions: This issue occurs after performing an admin shutdown on OC-3 controller.
Workaround: Perform no shutdown on the controller.
CSCug97639
•
Symptom: IPv4 VRF ping fails when disabling IPv6 unicast-routing globally on the router.
Conditions: This issue occurs when IPv6 unicast-routing is disabled.
Workaround: Enable IPv6 unicast-routing
CSCuh06123
•
Symptom: Incorrect quality level (QL) mapping between the clock class and quality level on the
PTP master.
Conditions: This issue is seen when QL value is configured before configuring the PTP master.
Workaround: Reconfigure the QL values or reload the router.
CSCuh18073
•
Symptom: In a domain with 2 BGP exit points acting in Active or Repair mode, the traffic exits the
domain through Repair Path BGP PE instead of exiting through Active Path BGP PE.
Conditions: This issue exists when the environment has 2 BGP exit points.
Workaround: There is no workaround.
• CSCuh22045
Symptom: Small MTU size is not fragmented on the OC-3 IM.
Conditions: This issue occurs after a reload and SSO is performed.
Workaround: Unconfigure and configure the IM.
CSCuh46103
•
Symptom: The BDI statistics do not get incremented on the router.
Conditions: This issue occurs when the ingress and egress statistics are displayed using the show
int erface bdi or show interface bdi stats command.
Workaround: Use show platform hardware pp active interface statistics bdi command.
CSCuh81658
•
Symptom: PTP packets are being treated as default packets even though QOS policy is configured
Conditions: Thi issue occurs afer CPU generated PTP packets do not reach egress QoS with high
priority label (15 or 126) and hence does not hit the corresponding default port entries or even the
EFP policy's control entries matching these labels.
Workaround: There is no workaround.
CSCuh93765
•
Symptom: The interface goes down reporting loss of frame alarm.
Conditions: This issue occurs on performing shutdown followed by a no shutdown on the PE and
CE.
Workaround: Perform an OIR on CE side.
CSCui22637
•
OL-26630-08
Caveats in Cisco IOS XE 3.10S Releases
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
4