Cisco ASR 903 Release Notes page 245

Hide thumbs Also See for ASR 903:
Table of Contents

Advertisement

Chapter
Open Caveats—Cisco IOS XE Release 3.10.1S
This section documents the unexpected behavior that might be seen with the Cisco ASR 903 router in
Cisco IOS XE Release 3.10.1S.
OL-26630-08
CSCue42139
Symptom: The ptp state is stuck in acquiring state all the time
Conditions: This issue occurs when the active RSP is removed; the T3 timestamping is stuck and the
ptp state stays in acquiring state all the time.
Workaround: Unconfigure and configure the ptp.
CSCuf78234
Symptom: The queue-limit command displays packets as default.
Conditions: This issue occurs when queue-limit command is configured on the router.
Workaround: Configure queue-limit is microseconds (us) or bytes.
CSCug97269
Symptom: The serial interface flaps when the neighbor controller is shut.
Conditions: This issue occurs occurs on performing shutdown on peer OC-3 controller with ATM or
IMA channels.
Workaround: There is no workaround.
CSCuh83433
Symptom: The path level controllers status on OC-3 IM sonet controller is not displayed after a
second SSO is triggered manually after removing the RSP.
Conditions: This issue is seen on hard RSP reset of RSP1.
Workaround: Perform a controller shutdown followed by a no shut down.
CSCui08697
Symptom: The interface LED glows green after SSO.
Conditions: This issue occurs after an SSO is performed and shut down of the ports on the router.
Workaround: There is no workaround.
CSCui34041
Symptom: Traffic does not flow on one of the prefix of the MPLS template.
Conditions: This issue occurs when the MAX MPLS label of that template is assigned to that prefix
Workaround: Disable and enable that prefix.
CSCui41169
Symptom: The active card reloads when standby become active after switchover with scaled
configurations.
Conditions: This issue occurs with 4000 EVCs with first and second level ingress policy. The Ingress
policy has one policer and the egress policy has one parent and child policer. This issue occurs with
reloading the card with this configuration.
Workaround: There is no workaround.
Caveats in Cisco IOS XE 3.10S Releases
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents