Chapter
Open Caveats—Cisco IOS XE Release 3.10S
This section documents the unexpected behavior that might be seen with the Cisco ASR 903 router in
Cisco IOS XE Release 3.10S.
•
•
•
•
•
•
OL-26630-08
CSCue36365
Symptom: During initial bootup of the serial interface module, the first character of the first packet
received might be missing.
Conditions: Problem occurs during a cold boot of the serial interface module.
Workaround: There is no workaround. Problem is a transient condition and traffic resumes after
receipt of the first message on the module.
CSCue42144
Symptom: PHY stops timestamping and the session stays at acquiring state.
Conditions: This issue is observed when you insert the Cu-SFP on the slave.
Workaround: There is no workaround.
CSCue49537
Symptom: The Cisco ASR 903 router crashes when you perform an OC3 IM OIR.
Conditions: This issue is observed when you have about 700 CEM circuits and perform an OC3 IM
OIR.
Workaround: There is no workaround.
CSCue87629
Symptom: The following error message is displayed:
INFRA-6-PROCPATH_CLIENT_HOG: IOS shim client 'iosd-nile'
Conditions: This issue is observed when you use the shutdown and no shutdown commands on
the G8032 ring interface of peer or local device.
Workaround: There is no workaround.
CSCuf16426
Symptom: FMAN_FP download fails and the following error message is displayed:
%CHUNK-2-BADREFCOUNT errors.
Conditions: Have an MPLS TE in the core and flap the tunnels intermittently.
Workaround: Do not flap the core TE tunnels often.
CSCug15175
Symptom: The Cisco ASR 903 router falsely displays the following error message saying that a
BFD node is down:
%OSPF-5-ADJCHG: Process 232, Nbr 192.0.2.33 on BDI632 from FULL to DOWN, Neighbor
Down: BFD node down
Conditions: This issue is observed when you configure a BFD software session.
Workaround: There is no workaround.
Caveats in Cisco IOS XE 3.10S Releases
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
10