Cisco ASR 903 Release Notes page 88

Caveats in Cisco IOS XE 3.7S Releases
Workaround: Reduce the rate of traffic.
CSCua99096
•
Symptoms: The show ima interface command omits some IMA group information such as
ImaGroupSymmetry.
Conditions: This issue occurs when the show ima interface command.
Workaround: There is no workaround.
CSCub94462
•
Symptom: The router displays object download error messages on the console.
Conditions: This issue occurs under the following conditions
–
–
–
Workaround: Avoid issuing the clear mac-address-table command when the mac security sticky
command is applied.
CSCuc08397
•
Symptom: When IFM is configured on EVC BD, with encapsulation default in the core, the remote
MEPS are not learnt.
Conditions: This issue is seen when encapsulation default is configured on the core facing side.
Workaround: There is no workaround.
CSCud09142
•
Symptom: FP active error messages are seen when the tunnel-tp interface is removed in a
high-availability setup.
Conditions: This issue is seen after removing tunnel-tp interface.
Workaround: There is no workaround.
CSCud34600
•
Symptom: Event hog messages are received when 21k to 25k routes are advertised into MBGP and
exported from one PE to another.
Conditions: This issue occurs when the redistributing routes range from 21k to 25k routes from
OSFP are moved into MBGP and are exported from one PE to another.
Workaround: There is no workaround.
CSCud90362
•
Symptom: the SYNC packets go out quite irregularly when PTP master is configured.
Conditions: This issue is seen when the router is configured as PTP master.
Workaround: There is no workaround.
• CSCue24854
Symptom: Loss of 70 msec are observed when performing an IM OIR in a remote LFA ring.
Conditions: This issue occurs when soft OIR is performed.
Workaround: Do a hard OIR to get less than 50 msec loss.
CSCue73478
•
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
6
Execute the mac address sticky command.
Configure 25 incremental MAC addresses and execute the clean mac-address-table bdomain
command
Remove a mac security sticky configuration from an EVC interface.
Chapter
OL-26630-08