Cisco ASR 903 Release Notes page 211

Workaround: Issue a shutdown followed by a no shutdown command again.
CSCug61508
•
Symptom: Classification based on ACL in the child does not work
Conditions: This issue occurs when the parent classification is EFP.
Workaround: There is no workaround.
CSCuf65301
•
Symptom: Micro flaps observed on the router.
Conditions: This issue is seen when system is kept idle for hours.
Workaround: There is no workaround.
CSCug67955
•
Symptom: The standby FP is stuck in init state.
Conditions: This issue occurs after ISSU is performed.
Workaround: There is no workaround.
• CSCug71853
Symptom: BFD flaps are observed on the router.
Conditions: This issue is seen when traffic flows at line rate.
Workaround: Keep traffic at around 90% line rate.
CSCug72785
•
Symptom: OSPF flap observed on the router.
Conditions: This issue occurs after IM OIR followed by SSO.
Workaround: There is no workaround.
CSCug73776
•
Symptom: The standby router crashes on bootup when highly scaled configurations and when
L2VPN and multicast are configured.
Conditions: This issue occurs on reloading the router 3-4 times with highly scaled configurations
and L2VPN and multicast are configured.
Workaround: There is no workaround.
CSCuh18073
•
Symptom: In a domain with 2 BGP exit points acting in Active or Repair mode, traffic would be
exiting the domain through Repair path BGP PE instead of exiting through Active path BGP PE.
Conditions: This issue occurs in the following conditions:
–
–
In this scenario, even after BGP convergence, data packets would traverse through previous primary
BGP PE(now repair path PE).
Workaround: There is no workaround.
OL-26630-08
Environment has 2 BGP exit points
A change in one of the core links to the primary BGP exit point results in Repair BGP PE
becoming Active BGP PE and vice versa
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.9S Releases
25