Cisco ASR 903 Release Notes page 179

Chapter
Workaround: There is no workaround; however, the router applies the QoS policy normally.
CSCua77688
•
Symptom: The router experiences remote CFM MEP flapping.
Conditions: Occurs when the router is connected via a CFM xconnect and the link is running a high
traffic rate.
Workaround: Reduce the rate of traffic.
CSCua90879
•
Symptom: QoS policies with a police statement on the class-default class do not take effect.
Conditions: Occurs when you apply a police statement to the class-default class within a QoS policy
on an ingress EVC interface.
Workaround: Apply the police statement to a static class, such as class cos0.
CSCub50477
•
Symptom: The router does not pass Multicast traffic after a stateful switchover (SSO).
Conditions: Occurs when you issue an SSO while the router is passing Multicast traffic on an
inbound MLP interface.
Workaround: There is no workaround.
CSCub65096
•
Symptom: The router crashes when running multicast traffic.
Conditions: Occurs when the router is passing IGMP join messages at a rate of 6 packets per second
over 240 serial interfaces.
Workaround: Send IGMP joins at a lower rate.
CSCub77354
•
Symptom: An RSP switchover causes the serial interfaces to flap on the peer device.
Conditions: Occurs when you perform an RSP switchover by physically removing the active RSP.
Workaround: Use the following workarounds:
–
–
• CSCub78861
Symptom: Following a reload, the router handles CFM only on 128 VLANs or bridge-domains.
Conditions: Occurs when the router configuration contains CFM and more than 128 VLANs or
bridge-domains.
Workaround: There is no workaround.
• CSCuc01154
Symptom: The router does not report B1, B2, and B3 alarms at normal thresholds.
Conditions: Occurs on the OC-3 interface module when the router sends errored frames.
Workaround: There is no workaround.
CSCuc02617
•
Symptom: The router stops passing MPLS LDP traffic.
OL-26630-08
Perform an RSP switchover using the redundancy force-switchover command.
Configure the local device to use clock source line and the remote device to use clock source
internal.
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.8S Releases
37