Chapter
Workaround: There is no workaround. Do not change the MAC address on the BDI interface.
CSCug17844
•
Symptom: Traffic does not match the configured class map of the applied policy.
Conditions: This issue is observed at egress, if a policy map which contains 8 user-defined
class-maps is applied. As it exceeds the allowed number of class maps, traffic hits the class default.
Workaround: Remove the 8th user-defined class map and reapply the policy.
CSCug18630
•
Symptom: When you perform an OIR on the standby and active RSPs, CMAND crashes.
Conditions: This issue is observed after performing multiple standby OIRs and bringing the standby
machine up.
Workaround: There is no workaround.
CSCug31212
•
Symptom: When you apply a policy map, the console shows an error message.
Conditions: This issue is observed when you apply a policy map with numbered ACLs.
Workaround: There is no workaround.
CSCug31645
•
Symptom: If you change the template on the router and change it again within two minutes, the
standby RSP is unable to synchronize with the new template and the router reloads twice.
Conditions: This issue is observed when you change the template, and change it again within two
minutes before reloading the router.
Workaround: Do not change the template and change it again within two minutes.
CSCug44762
•
Symptom: The POS interface stays down after using the shutdown and no shutdown commands.
Conditions: This is issue is observed when you use the shutdown and no shutdown commands on
the POS interface.
Workaround: Use the shutdown and no shutdown commands on the controller.
CSCug48534
•
Symptom: Multicast traffic is forwarded on untagged EFPs when snooping is enabled.
Conditions: This issue is observed when untagged EFPs are shutdown at least once after it comes
up.
Workaround: Reload the router or toggle IGMP snooping.
•
CSCug55586
Symptom: If you dynamically remove the egress markings, ingress marking does not work.
Conditions: This issue is observed if a marking is present at the logical level in the egress direction,
DM does not work.
Workaround: Use the egress set at leaf or PHB level.
OL-26630-08
Caveats in Cisco IOS XE 3.10S Releases
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
23