CSCue75372
•
Symptom: Time-Hog traceback seen after router or IM reloads.
Conditions: This issue occurs on bootup of IM or router.
Workaround: There is no workaround.
CSCue87629
•
Symptom: INFRA-6-PROCPATH_CLIENT_HOG: IOS shim client "iosd-nile" messages may
appear on the console.
Conditions: This issue occurs when a shutdown followed by a no shutdown command is executed
on the G8032 ring interface of a peer or local device.
Workaround: There is no workaround.
CSCue92393
•
Symptom: CEM SatoP circuits with the router in Core remain in down state after initial
configuration. The show cem circuit command output on ASR903 shows that the circuits are down.
Conditions: This issue occurs when the CEM SatoP circuits are configured using script via tcl and
tftp_config. This forces a lot of configuration dump on router console simultaneously. The issue may
also be seen after router reload with saved CEM Satop configurations.
Workaround: Perform a controller shutdown followed by a no shutdown on OC-3 IM on the router.
•
CSCuf05090
Symptom: Standby IM resets continuously with running configuration synchronization failure.
Conditions: This issue occurs after a downgrade of all IMs and the IMS are removed from the slot
and a upgrade is performed.
Workaround: Reload the router completely.
CSCuf35542
•
Symptom: PFM is fails for about 5minutes after OIR on the master.
Conditions: This issue occurs after OIR is performed two times on the master
Workaround: Wait for 5-6 minutes after the OIR.
CSCuf79397
•
Symptom: F1 is stuck in init state after the standby RSP reloads.
Conditions: This issue occurs on a reload or OIR of the standby RSP.
Workaround: Reload the standby RSP again.
CSCug05491
•
Symptom: The router drops traffic on VPLS circuits.
Conditions: This issue occurs when you take the following actions:
–
–
–
Workaround: There is no workaround.
OL-26630-08
Configure REP with VLAN load balancing
Configure VPLS VFI on the VLANs
Issue an stateful switchover (SSO)
Cisco IOS XE 3S Release Notes for the Cisco ASR 903 Router
Caveats in Cisco IOS XE 3.9S Releases
15