Solid-State Drive - HP Pavilion m6 Maintenance And Service Manual

Solid-state drive

Description
32-GB solid-state drive (for use only on computer models equipped with an Intel processor)
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the wireless module compartment cover (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the base enclosure.
(The solid-state drive tilts up.)
2. Remove the solid-state drive by pulling the drive away from the slot at an angle (2).
Reverse this procedure to install the solid-state drive.
Battery on page 48).
Hard drive on page 49).
WLAN module on page
Component replacement procedures
Spare part number
686927-001
62).
65