Winding On The Hook Thread - Duerkopp Adler 512/532 Operating Manual

4.4
Fig. 4: Winding on the hook thread
(1) - Tension
(2) - Guide
(3) - Bobbin-winder lever
1. Place the bobbin (5) on the winder shaft (4).
2. Pull the thread through the guide (2) and around the tensioner (1).
3. Wind the thread approx. 5 x anticlockwise around the bobbin core (5).
4. Press the bobbin-winder lever (3) into the bobbin.
5. Start sewing.
6. After winding, tear off the thread at thread clamp (6).
Tip
If you want to wind on the thread without sewing, you can set thread wind-
ing mode on the control unit.
16

Winding on the hook thread

6
5
4
• After reaching the set bobbin fill quantity (see Service Manual) the
bobbin winder switches off automatically.
3
(4) - Winder shaft.
(5) - Bobbin
(6) - Thread clamp
Operating manual 512/532 Version 01.0 - 03/2013
Operating manual
1
2