6.4 Winding on the hook thread
10
4
3
–
Thread the hook thread as shown in the picture above.
–
Fit the bobbin 3 on the bobbin-winder shaft 2.
–
Wind approximately five coils of hook thread anti-clockwise onto
the bobbin core.
–
Cut the thread end with the knife and clamp it.
–
Press the release lever 1 against the bobbin.
The bobbin-winder wheel is pressed against the driving wheel of
the arm shaft.
–
Adjusting the tension 4.
The hook thread should be wound on with minimum tension.
–
Sewing.
The release lever 1 terminates the process automatically as soon
as the bobbin is full.
2
1