Table of Contents
Advertisement
Settings via software
1. Press the Ready button.
2. Press the Ready button.
3. Press the Selection button until the LED in the Wind icon is lit.
4. Press the Ready button.
5. Push the pedal forward.
6. To stop winding, push the pedal fully to the front.
7. Press the Ready button.
5.9
Preconditions:
• The machine is in sewing mode; the LED in the Ready button is lit.
• Needle fitted.
• Needle thread threaded.
• Sewing pattern selected.
1. Insert the material.
2. Push the foot pedal forward to the first position.
3. Push the foot pedal fully forward.
5.10 Counter
The counter can be used as a unit counter (parameter number U020) or
as an automatic stop counter (parameter number U076).
Preconditions:
• The machine is in programming mode; the LED in the Ready button is
1. Press the Selection button until the LED in the Counter icon is lit.
2. Press the Reset button to set the counter to 0.
3. Press the +/- Function buttons to set the cycle count.
4. Insert a new bobbin.
5. Press the Reset button.
Operating manual 512/532 Version 01.0 - 03/2013
The LED in the Ready button is lit.
The LED in the button is unlit.
The LED in the button is lit; the clamp is lowered.
Winding starts.
The LED in the button is unlit; the clamp is raised.
Sewing
The clamp is lowered.
If you release the pedal, the clamp is raised.
The sewing process starts. At the end of sewing, the clamp is automat-
ically raised.
unlit.
Each sewing end decrements the counter by 1.
After reaching the preset number of cycles, a message appears in the
display.
The counter is reset
27
Advertisement
Table of Contents
