Wlan And Maintenance Settings; Logging In To The Web Configurator In Ap Mode; Table 24 Network > Lan > Ip - ZyXEL Communications NBG334S User Manual

Chapter 4 AP Mode
The table below describes the labels in the screen.
Table 24 Network > LAN > IP
LABEL
Get form
DHCP Server
User Defined
LAN IP
IP Address
IP Subnet
Mask
Gateway IP
Address
Apply
Reset

4.4.2 WLAN and Maintenance Settings

The configuration of wireless and maintenance settings in AP Mode is the same as for Router
Mode.
• See Chapter 5 on page 69
• See Maintenance and Troubleshooting (171)
Maintenance settings.

4.5 Logging in to the Web Configurator in AP Mode

1 Connect your computer to the LAN port of the NBG334S.
2 The default IP address if the NBG334S is "192.168.1.1". In this case, your computer
must have an IP address in the range between "192.168.1.2" and "192.168.1.255".
3 Click Start > Run on your computer in Windows.
4 Type "cmd" in the dialog box.
5 Type "ipconfig" to show your computer's IP address. If your computer's IP address is
not in the correct range then see
your computer's IP address.
6 After you've set your computer's IP address, open a web browser such as Internet
Explorer and type "192.168.1.1" as the web address in your web browser.
See Chapter 6 on page 89
66
DESCRIPTION
Select this option to allow the NBG334S to obtain an IP address from a DHCP server
on the network. You must connect the WAN port to a device with a DHCP server
enabled (such as a router or gateway). Without a DHCP server the NBG334S will
have no IP address. You need to find out the IP address the DHCP server assigns to
the NBG334S and use that address to log in to the NBG334S again.
Select this option to set the NBG334S's IP address. This setting is selected by
default. Check the IP address is on the same domain as other devices on your
network.
Type the IP address in dotted decimal notation. The default setting is 192.168.1.1. If
you change the IP address you will have to log in again with the new IP address.
The subnet mask specifies the network number portion of an IP address. Your
NBG334S will automatically calculate the subnet mask based on the IP address that
you assign. Unless you are implementing subnetting, use the subnet mask computed
by the NBG334S.
Type the IP address of the gateway. The gateway is an immediate neighbor of your
NBG334S that will forward the packet to the destination. In AP Mode, the gateway
must be a router on the same segment as your NBG334S.
Click Apply to save your changes to the NBG334S.
Click Reset to reload the previous configuration for this screen.
for information on the configuring your wireless network.
Appendix D on page 231
for a tutorial on setting up a network with an AP.
for information on the configuring your
for information on changing
NBG334S User's Guide