Static Route Setup Screen; Figure 75 Management > Static Route > Ip Static Route; Table 54 Management > Static Route > Ip Static Route - ZyXEL Communications NBG334S User Manual

Chapter 14 Static Route Screens
Figure 75 Management > Static Route > IP Static Route
The following table describes the labels in this screen.
Table 54 Management > Static Route > IP Static Route
LABEL
#
Name
Active
Destination
Gateway
Modify

14.2.1 Static Route Setup Screen

To edit a static route, click the edit icon under Modify. The following screen displays. Fill in
the required information for each static route.
140
DESCRIPTION
This is the index number of an individual static route. The first entry is for the
default route and not editable.
This is the name that describes or identifies this route.
This icon is turned on when this static route is active.
Click the Edit icon under Modify and select the Active checkbox in the Static
Route Setup screen to enable the static route. Clear the checkbox to disable this
static route without having to delete the entry.
This parameter specifies the IP network address of the final destination. Routing
is always based on network number.
This is the IP address of the gateway. The gateway is an immediate neighbor of
your NBG334S that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your NBG334S; over the
WAN, the gateway must be the IP address of one of the remote nodes.
Click the Edit icon to open the static route setup screen. Modify a static route or
create a new static route in the Static Route Setup screen.
Click the Remove icon to delete a static route.
NBG334S User's Guide