Maytag W10550279A Use & Care Manual page 13

f
NON-USE AND VACATION CARE
Operate your washer only when you are home, If moving, or not
using your washer for a period of time, follow these steps:
1. Unplug or disconnect power to washer,
2. Turn off water supply to washer, to avoid flooding
due to water pressure surge,
r
WINTER STORAGE CARE
IMPORTANT:
To avoid damage, install and store washer where
it will not freeze, Because some water may stay in hoses, freezing
can damage washer, If storing or moving during freezing weather,
winterize your washer,
To winterize washer:
1. Shut off both water faucets; disconnect and drain water inlet
hoses.
2. Put 1 qt. (1 L) of R,V.-type antifreeze in basket and run washer
on RINSE/DRAIN & SPIN cycle for about 30 seconds to mix
antifreeze and remaining water,
3. Unplug washer or disconnect power,
f
TRANSPORTING YOUR WASHER
1. Shut off both water faucets, Disconnect and drain water
inlet hoses,
2. If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving,
3. Disconnect drain from drain system,
4. Unplug power cord,
5. Place inlet hoses inside washer basket,
6. Drape power cord and drain hose over the console
and secure with masking tape,
7. Place foam packing ring from original shipping materials
back inside washer, If you do not have packing ring, place
heavy blankets or towels into basket opening, Close lid and
place tape over lid and down front of washer, Keep lid taped
until washer is placed in new location,
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
r
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage or
moving:
1. Refer to Installation Instructions to locate, level, and connect
washer,
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses, Reconnect water inlet hoses,
Turn on both water faucets,
2. Plug in washer or reconnect power,
3. Run washer through BULKY cycle to clean washer and
remove antifreeze, if used, Use only HE High Efficiency
detergent, Use half the manufacturer's recommended amount
for a medium-size load,
13