Chapter 3
Setting Up the Cisco Unified IP Phone
Installing the Cisco Unified IP Phone
Note
Note
Procedure
Connect the handset to the
1.
Handset port.
Connect a headset to the
2.
Headset port.
Connect the power supply to
3.
the Cisco DC Adapter port.
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.1 (SIP), Cisco Unified IP Phones
OL-11524-01
You must connect the Cisco Unified IP Phone to the network and to a power
source before using it. See
connections.
Before you install a phone, even if it is new, upgrade the phone to the current
firmware image.
Before using external devices, read the
Unified IP Phone" section on page 3-8
To install a Cisco Unified IP Phone, perform the following steps:
Notes
—
Optional. You can add a headset
later if you do not connect one
now.
Optional.
Installing the Cisco Unified IP Phone
Figure 3-1
for a graphical representation of the
"Using External Devices with Your Cisco
for safety and performance information.
Reference
—
See the
page 3-6
See the
Phone" section on page
"Headset" section on
for supported headsets.
"Providing Power to the
2-4.
3-9