Verifying Ip Addressing And Routing - Cisco 7970G Administration Manual

Chapter 9 Troubleshooting and Maintenance

Verifying IP Addressing and Routing

Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.1 (SIP), Cisco Unified IP Phones
OL-11524-01
If you are using DHCP, the phone obtains the address for the TFTP server from
the DHCP server. Check the IP address configured in Option 150.
You can also enable the phone to use an alternate TFTP server. Such a setting is
particularly useful if the phone was recently moved from one location to another.
See the "Network Configuration Menu" section on page 4-7
You should verify the IP addressing and routing settings on the phone. If you are
using DHCP, the DHCP server should provide these values. If you have assigned
a static IP address to the phone, you must enter these values manually.
On the Cisco Unified IP Phone, press the Settings button, choose Network
Configuration, and look at the following options:
DHCP Server—If you have assigned a static IP address to the phone, you do
•
not need to enter a value for the DHCP Server option. However, if you are
using a DHCP server, this option must have a value. If it does not, check your
IP routing and VLAN configuration. Refer to Troubleshooting Switch Port
Problems, available at this URL:
http://www.cisco.com/warp/customer/473/53.shtml
IP Address, Subnet Mask, Default Router—If you have assigned a static IP
•
address to the phone, you must manually enter settings for these options. See
the "Network Configuration Menu" section on page 4-7
If you are using DHCP, check the IP addresses distributed by your DHCP server.
Refer to Understanding and Troubleshooting DHCP in Catalyst Switch or
Enterprise Networks, available at this URL:
http://www.cisco.com/warp/customer/473/100.html#41
Resolving Startup Problems
for instructions.
for instructions.
9-5