Adding Phones With Cisco Unified Callmanager Administration; Adding Phones With Bat - Cisco 7970G Administration Manual

Adding Phones to the Cisco Unified CallManager Database

Adding Phones with Cisco Unified CallManager Administration

Adding Phones with BAT

Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.1 (SIP), Cisco Unified IP Phones
2-16
Chapter 2
You can add phones individually to the Cisco Unified CallManager database
using Cisco Unified CallManager Administration. To do so, you first need to
obtain the MAC address for each phone.
For information about determining a MAC address, see the
MAC Address of a Cisco Unified IP Phone" section on page
After you have collected MAC addresses, choose Device > Add a New Device in
Cisco Unified CallManager Administration to begin.
For complete instructions and conceptual information about Cisco Unified
CallManager, refer to Cisco Unified CallManager Administration Guide and to
Cisco Unified CallManager System Guide.
Related Topics
Adding Phones with Auto-Registration, page 2-14
•
Adding Phones with Auto-Registration and TAPS, page 2-15
•
Adding Phones with BAT, page 2-16
•
The Cisco Bulk Administration Tool (BAT) is a plug-in application for
Cisco Unified CallManager that enables you to perform batch operations,
including registration, on multiple phones.
To add phones using BAT only (not in conjunction with TAPS), you first need to
obtain the appropriate MAC address for each phone.
For information about determining a MAC address, see the
MAC Address of a Cisco Unified IP Phone" section on page
Preparing to Install the Cisco Unified IP Phone on Your Network
"Determining the
2-20.
"Determining the
2-20.
OL-11524-01