Warning Labels - Toshiba G8000 SERIES Installation And Operation Manual

6

Warning Labels

Below are representative warning labels and their location on the UPS. Exterior Handling labels shown in
section 4.3, Transporting/Unpacking, are in the manual packet, and attached to the UPS shipping cover-
ing and shipping pallet.
Make sure all the warning labels are installed in the appropriate locations.
If a label is missing or illegible, contact Toshiba Customer Support Center or an
authorized representative.
(A)
48082
DANGER
AC VOLTAGE
This UPS receives power from more
than one source. Disconnect all AC
sources before performing any service
or testing inside this unit
(C)
56875 FOR 80, 100, 150, 225 KVA
56875 FOR 100, 150, 225KVA
USE COPPER CONDUCTORS ONLY!
REFER TO INSTRUCTION MANUAL FOR WIRE SIZE AND TIGHTENING TORQUE
1 2 3 4 5 6 7
U V W U V W N
480 V
480 V
A C INPUT
BYPA SS INPUT
(C)
58708 FOR 300KVA
USE COPPER CONDUCTORS ONLY !
REFER TO INSTRUCTION MANUAL FOR WIRE SIZE AND TIGHTENING TORQUE
1 2 3 6 7
4 5
-
+
U V W U V
480 V 400 V
A C INPUT BATTERY
BYPASS INPUT
(E)
14
39561
DANGER
RISK OF ELECTRIC SHOCK
Capacitors stay c harged after power
has been s hut off.
Accidental contact with liv e parts can
NOTICE
48082
8 9 10 11 12 13
-
+
U V W N
480V 400 V
AC OUTPUT BATTERY
8 9 10 11 12
W N U V W
480 V
480 V
AC OUTPUT
(F)
58705 SERIAL LABEL
UNINTERRUPTIBLE POWER SUPPLY
(B)
40308
DANGER
HAZARDOUS VOLTAGES
Hazardous voltages are used in the operation
of this equipment and could cause severe personal
injury or loss of life.
The following precautions should be observed to
reduce the risk of injury or death.
Only qualified technicians familiar with this equipment and the
information supplied with it should be permitted to install and
operate this equipment.
Installation of electrical equipment must be done in
accordance with National Electrical Code and any other state
or local codes. Proper grounding and conductor sizing must
be installed for safe operation.
During operation, keep all covers in place and cabinet
doors shut.
When performing visual inspections and maintenance, if
possible, be sure the UPS is turned off and the incoming
AC feed is turned off and locked out.
The UPS and Battery Cabinet will have hazardous
voltages present even after the AC feed is turned off.
If it is necessary to make measurements with the power
on, do not touch any electrical connection points. Remove
all jewelry from wrists and fingers. Make sure test equipment
is in good, safe operating condition.
While servicing, stand on some type of insulation, and be
sure not to be grounded.
Follow the safety instructions given in the equipment manual
carefully and observe all danger, warning and caution notices.
(D)
40830
WA R N I N G
CRITICAL FUSE SIZING
Incorrect fuse replacement size
may result in fire or inadequate
equipment protection.
Replace only with same type
and rating of fuse.
PN 40830
(G)
57055
G8000 Series Installation and Operation Manual
GND
40308