Xerox 4595 User Manual page 401

Category
Error Code
C P S M O
016-786
016-787
016-788
016-789
016-791
016-792
016-793
016-799
021-750
021-751
021-770
021-771
021-772
024--746
024-747
X er o x 4 5 95 Co pi e r /P r i n te r U s e r G u i de
Cause and Remedy
When using the scan feature, hard disk capacity is
Cause
insufficient for writing to a file.
Either remove unnecessary data from the hard disk to
Remedy
increase free disk space or initialize the hard disk.
Invalid server IP address specified in job template.
Cause
Specify the correct job template.
Remedy
Failed to load a file from the Web browser.
Cause
Perform the following actions, and try again.
Remedy
• Reload the browser page
• Restart the browser
• Power-cycle the machine
Insufficient space available for mail processing.
Cause
Processing was interrupted.
Reduce resolution or reduction/enlargement ratio to
Remedy
decrease the data size, or send in several pieces.
In the scanner (save to PC) or job template scan, the
Cause
forwarding destination or job template save location
could not be accessed.
Check whether you can access the specified forwarding
Remedy
destination.
Specified job history could not be acquired when printing
Cause
Job Counter Report
Specified job history does not exist.
Remedy
The hard disk has run out free space.
Cause
Either remove unnecessary data from the hard disk to
Remedy
increase free disk space or initialize the hard disk.
An illegal print parameter is included.
Cause
Confirm the print data and option and specify the print
Remedy
data again.
During an inspection or maintenance request a
Cause
transmission error occurred and our Customer Support
Center could not be contacted.
Check that the phone lines are connected and try
Remedy
sending an inspection or maintenance request again
after a short time.
If the error persists, contact the Customer Support
Center.
A feature (one of paper size, tray, output tray, or 2 sided
Cause
printing) that is incompatible with the specified paper
quality has been specified.
Check the print data.
Remedy
An illegal print parameter combination was set. For
Cause
example, a non-standard size was specified and
Tray Selection was set to Auto.
Check the print data. In the above case, select Tray 5
Remedy
(Bypass).
11 . P r o b le m S o l vi n g
11-39